![]() Locate and loosen the screws on the back of the plug for each of the three wire terminals.Follow steps 5-7 to strip and expose the copper wire from the above guide.Insert the plug shell after the cord grip.Follow steps 1-3 from the Socket Wiring Guide above.Separate the prongs from the rest of the plug.Plug Prong Wiring Download PDF Full screen Screw the plastic part of the grip into place to secure it on the cord.Īnd part one of how to make a light fixture is complete! 2.Slide the cord grip all the way down to meet the socket.Align the cap with the shell and twist it into place (Once locked, you WILL NOT be able to reopen this piece).Complete steps 9-11 with the white and black wires – black to the positive and white to the negative terminal in the cap.Secure the green wire to the hole inside the cap with the screw.Insert the green wire through the top of the cap to connect it with the ground terminal.Bend the exposed copper of the green wire at a 90-degree angle.Flip the cap upside down and locate the screw to the ground terminal to loosen it.Strip each of the three internal wires to expose the copper and twist the stranded wires.Confirm that the conductor wires are intact and untouched by your stripping tool.Strip the PVC housing on the cord from the center of the tape to the end of the cord.Pull it through at least 1.25” and wrap electrical tape in that spot as a marker.Thread the tape-wrapped cloth-covered cord into the grip. ![]() ![]() Confirm that the plastic screw is not penetrating the grip interior.Loosen the plastic screw on the cord grip to open up the inside.What You Need to Make Your Own Light Fixture
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |